New alloy wheels for the 560SEC

My 560SEC came with a set of Simmons wheels.  These wheels are not to my taste and were too wide for the car.   The wheels had been mounted with spacers which I do not like.    On Thursday, I secured a great set of 15×7 Mercedes wheels which I fitted to the 450SLC.   This meant that the ASA Type 8 wheels I had on the SLC were available for the 560SEC.   These wheels have come full circle as I originally purchased them for a 560SEC.

The ASA Type 8 wheels are a replica of the 8 hole alloy wheels found on cars such as the W140 and R129.   They are easy to keep clean and look good on the W126.    At least when I purchased them back in 2009, ASA Type 8 wheels could be bought with both low and high offsets.

ASA Type 8

These wheels are a huge improvement over the Simmons wheels.   The 560SEC is an elegant car, but this one had been fitted with some gaudy accessories that I am slowly removing.   After almost 10 years and 50,000km it was time to replace the Yokohama Avid V4S tyres on them.   Given the mileage I now do on these cars, tread wear is not a primary concern.   Tyres only last about 8-10 years even if they still have tread left on them.   Based on the mileage I do, i went with a more budget performance tyre.  It will be interesting to see how well they go.    I purchased a set of Laufenn S FIT EQ.   Apparently this is a subsidiary of Hankook and the tyres seem to get good reviews.   At more than $50 per tyre less than Michelin it seemed worth a try.

W123

While I was having the tyres fitted I noticed a very familiar car.   Back when I used to commute every day to the eastern suburbs between 1998-2001 I used to see this same car.  Even though I don’t know the owner, I recognized the number plate (starts with MSA).    I remember it because I had a very similar W123 230E at the time.    The fate of my 230E is unknown, so I am very happy to see this one still on the road.

I am going on a Mercedes Club drive this evening.   I was planning to drive the 250SE, but since rain is forecast, I will take the 560 and see how the new tyres perform.

You may also like...

2 Responses

  1. December 20, 2021

    […] my 450SLC goes back to late 2018 when I purchased my 560SEC.   At the time, it came with a set of Simmons wheels.   They are a high quality Australian made wheel that are very popular on Fords.   I […]

  2. September 15, 2024

    […] a terrible wheel wobble; and I didn’t think the suited the car.   I sold those wheels and replaced them with the replica 8 hole wheels I had on my 450SLC at the time.   I only saw those wheels as a […]

Leave a Reply

Your email address will not be published. Required fields are marked *

Classic Jalopy